Altronix EFLOW4NA8D eflow4nx pwr sply w/acm8cb

• Input:

• Input 120VAC 60Hz, 3.5 amp.
• Power supply input options:
• a) One (1) common power input for ACM8CB and lock power (factory installed).
• b) Two (2) isolated power inputs - One (1) to power the ACM8CB and one (1) for lock accessory power (external power supply is required). Current is determined by the power supply connected, not to exceed a maximum of 10 amp total.
• Eight (8) Access Control System trigger inputs.
• Input options:
• a) Eight (8) normally open (NO) inputs.
• b) Eight (8) open collector inputs.
• c) Any combination of the above.

• Output:

• 12VDC or 24VDC outputs @ 4 amp supply current.
• Power-limited outputs.
• Eight (8) independently trigger controlled outputs.
• Output options:
• a) Eight (8) Fail-Safe filtered power outputs.
• b) Eight (8) Fail-Secure filtered power outputs.
• c) Any combination of the above.
• Eight (8) unswitched filtered aux. power outputs (outputs are rated @ 2 amp).
• Over Voltage protection.
• Short circuit and thermal overload protection.

• Fire Alarm Disconnect:

• Fire Alarm disconnect (latching or non-latching) is individually selectable for any or all of the eight (8) outputs.
• Fire Alarm disconnect input options:
• a) Normally open (NO) or normally closed (NC) dry contact input.
• b) Polarity reversal input from FACP signaling circuit.
• Alarm output relay indicates that FACP input is triggered (form "C" contact rated @ 1 amp 28VDC not evaluated by UL).

• Supervision:

• AC fail supervision (form "C" contacts).
• Battery fail & presence supervision (form "C" contacts).
• Low power shutdown. Shuts down DC output terminals if battery voltage drops below 71-73% for 12V units and 70-75% for 24V units (depending on the power supply). Prevents deep battery discharge.

• Visual Indicators:

• ACM8CB Access Power Controller:

• Red LEDs indicate outputs are triggered (relays energized).
• Green LED indicates FACP disconnect is triggered.

• eFlow Power Supply Board:

• AC input and DC output LED indicators.

• Battery Backup:

• Built-in charger for sealed lead acid or gel type batteries.
• Power Supply Board maximum charge current 1.54 amp.
• Automatic switch over to stand-by battery when AC fails. Transfer to stand-by battery power is instantaneous with no interruption.
• Zero voltage drop when unit switches over to battery backup (AC failure condition).

• Electrical:

• Operating temperature: 0 ° C to 49 ° C ambient.
• ACM8CB board main fuse is rated at 10 amp.
• BTU/Hr.:
• - 12VDC: 24.57 BTU/Hr.
• - 24VDC: 49.45 BTU/Hr.
• Lifetime Warranty

Customer Reviews

(0.00) stars out of 5

# of Ratings: 0